SP8EBC Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8EBC. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Rx10min*	Vbatt*
1753299401	32 Pkt	12.8 V
1752999766	53 Pkt	12.52 V
1752999166	36 Pkt	12.54 V
1752998566	38 Pkt	12.54 V
1752997963	43 Pkt	12.54 V
1752996762	41 Pkt	12.54 V
1752996162	42 Pkt	12.46 V
1752995561	31 Pkt	12.52 V
1752994504	34 Pkt	12.54 V
1752993904	33 Pkt	12.54 V
1752993303	33 Pkt	12.46 V
1752992703	33 Pkt	12.54 V
1752992101	37 Pkt	12.54 V
1752991501	43 Pkt	12.48 V
1752990898	45 Pkt	12.52 V
1752990297	45 Pkt	12.54 V
1752989696	36 Pkt	12.5 V
1752989095	32 Pkt	12.52 V
1752988483	43 Pkt	12.52 V
1752987881	42 Pkt	12.54 V
1752987278	49 Pkt	12.52 V
1752986678	36 Pkt	12.54 V
1752986077	37 Pkt	12.56 V
1752985477	44 Pkt	12.54 V
1752984876	44 Pkt	12.5 V

*Used Equation Coefficients:

Rx10min: 0, 1, 0

Visc10min: 0, 1, 0

Digi10min: 0, 1, 0

Vbatt: 0, 0.02, 10

Tempre: 0, 0.5, -50

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)