SQ5STR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789956025	14 Count	614 Count
1789954225	13 Count	564 Count
1789952424	12 Count	524 Count
1789950623	11 Count	487 Count
1789948823	10 Count	447 Count
1789947022	9 Count	409 Count
1789945221	8 Count	363 Count
1789943420	7 Count	325 Count
1789941620	6 Count	282 Count
1789939819	5 Count	242 Count
1789938018	4 Count	214 Count
1789936217	3 Count	182 Count
1789934425	2 Count	142 Count
1789932624	1 Count	92 Count
1789929023	20 Count	1011 Count
1789927222	19 Count	968 Count
1789925422	18 Count	918 Count
1789923621	17 Count	868 Count
1789921819	16 Count	835 Count
1789920018	15 Count	774 Count
1789918218	14 Count	691 Count
1789916417	13 Count	647 Count
1789914616	12 Count	607 Count
1789912823	11 Count	574 Count
1789911023	10 Count	528 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)