NCFPD Telemetry

This is the latest recevied telemetry packets stored in our database for station/object NCFPD. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*
1788636847	137	140	42
1788636547	137	140	42
1788636247	137	140	42
1788635947	137	139	41
1788635647	137	140	42
1788635347	137	140	42
1788635048	137	140	42
1788634747	137	140	42
1788634447	137	140	42
1788634147	137	140	42
1788633848	137	140	42
1788633547	137	139	41
1788633250	137	140	42
1788632947	137	140	42
1788632647	137	140	42
1788632348	137	140	42
1788632048	137	140	42
1788631747	137	140	42
1788631449	137	140	42
1788631147	137	140	42
1788630847	137	140	42
1788630547	137	140	42
1788630248	137	140	42
1788629948	137	140	42
1788629647	137	140	42

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)