IZ8AWQ-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ8AWQ-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1765578352	13.95 Volt	0 Pcnt
1765577152	13.95 Volt	0 Pcnt
1765574752	13.95 Volt	60 Pcnt
1765573552	13.95 Volt	80 Pcnt
1765572352	13.95 Volt	100 Pcnt
1765571152	13.95 Volt	100 Pcnt
1765569952	13.95 Volt	50 Pcnt
1765568752	13.95 Volt	41 Pcnt
1765567552	13.95 Volt	38 Pcnt
1765565152	13.95 Volt	55 Pcnt
1765563952	13.95 Volt	66 Pcnt
1765562753	13.95 Volt	62 Pcnt
1765561553	13.95 Volt	62 Pcnt
1765560353	13.95 Volt	55 Pcnt
1765559153	13.95 Volt	66 Pcnt
1765557953	13.95 Volt	62 Pcnt
1765556753	13.95 Volt	71 Pcnt
1765555553	13.95 Volt	66 Pcnt
1765554353	13.95 Volt	71 Pcnt
1765553153	13.95 Volt	85 Pcnt
1765551953	13.95 Volt	83 Pcnt
1765550753	13.95 Volt	100 Pcnt
1765549553	13.95 Volt	100 Pcnt
1765548353	13.95 Volt	100 Pcnt
1765547153	13.95 Volt	100 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)