F4JTC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4JTC-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772721568	82 Count	105 Count	66 Count
1772721265	77 Count	97 Count	62 Count
1772720961	74 Count	95 Count	60 Count
1772720678	67 Count	86 Count	54 Count
1772720050	61 Count	80 Count	50 Count
1772719746	57 Count	76 Count	47 Count
1772719442	53 Count	73 Count	44 Count
1772719139	40 Count	60 Count	32 Count
1772718831	26 Count	44 Count	19 Count
1772718524	23 Count	41 Count	17 Count
1772718220	20 Count	39 Count	15 Count
1772717917	19 Count	39 Count	15 Count
1772717606	15 Count	35 Count	12 Count
1772717302	11 Count	32 Count	9 Count
1772716998	9 Count	21 Count	8 Count
1772716694	6 Count	14 Count	6 Count
1772716391	787 Count	1003 Count	563 Count
1772716087	783 Count	993 Count	560 Count
1772715783	777 Count	986 Count	555 Count
1772715478	773 Count	981 Count	553 Count
1772715174	771 Count	979 Count	552 Count
1772714867	767 Count	975 Count	549 Count
1772714563	762 Count	970 Count	545 Count
1772714259	760 Count	967 Count	544 Count
1772713956	758 Count	966 Count	543 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)