SO9G-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SO9G-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780580281	41 Count	746 Count	33 Count
1780578487	38 Count	666 Count	31 Count
1780576686	34 Count	567 Count	28 Count
1780574885	29 Count	464 Count	24 Count
1780573085	25 Count	374 Count	21 Count
1780571284	22 Count	291 Count	19 Count
1780569484	18 Count	211 Count	16 Count
1780567683	12 Count	130 Count	11 Count
1780565883	9 Count	67 Count	9 Count
1780564082	66 Count	1009 Count	51 Count
1780562281	62 Count	952 Count	48 Count
1780560481	56 Count	879 Count	43 Count
1780558680	50 Count	803 Count	38 Count
1780556886	47 Count	739 Count	36 Count
1780555086	43 Count	671 Count	33 Count
1780553285	38 Count	592 Count	29 Count
1780551484	33 Count	534 Count	25 Count
1780549684	30 Count	460 Count	23 Count
1780547883	26 Count	369 Count	20 Count
1780546082	22 Count	307 Count	17 Count
1780544282	18 Count	244 Count	14 Count
1780542481	13 Count	180 Count	10 Count
1780540681	9 Count	126 Count	7 Count
1780538880	5 Count	72 Count	4 Count
1780537079	0 Count	0 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)