SR2SAT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2SAT-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1753817971	310 Count	894 Count	216 Count
1753816170	307 Count	887 Count	214 Count
1753814370	305 Count	873 Count	213 Count
1753812569	303 Count	865 Count	212 Count
1753805367	294 Count	825 Count	207 Count
1753803566	292 Count	815 Count	206 Count
1753799978	288 Count	796 Count	204 Count
1753796370	279 Count	721 Count	201 Count
1753794569	277 Count	704 Count	200 Count
1753792769	275 Count	693 Count	199 Count
1753789167	270 Count	672 Count	196 Count
1753787367	257 Count	655 Count	184 Count
1753783766	254 Count	618 Count	183 Count
1753781965	245 Count	604 Count	175 Count
1753780191	229 Count	577 Count	160 Count
1753778364	215 Count	551 Count	147 Count
1753774770	199 Count	506 Count	137 Count
1753771169	177 Count	462 Count	117 Count
1753769368	174 Count	455 Count	115 Count
1753767567	172 Count	424 Count	114 Count
1753765767	169 Count	376 Count	112 Count
1753763966	166 Count	364 Count	110 Count
1753762166	163 Count	354 Count	108 Count
1753760364	158 Count	342 Count	104 Count
1753758563	155 Count	331 Count	102 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)