OK1OBR-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784700123	559 Count	286 Count	120 Count
1784698319	552 Count	279 Count	114 Count
1784696515	551 Count	278 Count	114 Count
1784694711	550 Count	278 Count	114 Count
1784692908	549 Count	278 Count	114 Count
1784691104	548 Count	278 Count	114 Count
1784689300	547 Count	278 Count	114 Count
1784687542	546 Count	278 Count	114 Count
1784685738	545 Count	278 Count	114 Count
1784683934	544 Count	278 Count	114 Count
1784682130	543 Count	278 Count	114 Count
1784680326	542 Count	278 Count	114 Count
1784678522	541 Count	278 Count	114 Count
1784676718	540 Count	278 Count	114 Count
1784674915	539 Count	278 Count	114 Count
1784673111	538 Count	278 Count	114 Count
1784671307	537 Count	278 Count	114 Count
1784669503	536 Count	278 Count	114 Count
1784667699	535 Count	278 Count	114 Count
1784665942	534 Count	278 Count	114 Count
1784664138	533 Count	278 Count	114 Count
1784662334	532 Count	278 Count	114 Count
1784660530	531 Count	278 Count	114 Count
1784658726	530 Count	278 Count	114 Count
1784656922	529 Count	278 Count	114 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)