Overview Statistics Trail Chart Weather Telemetry Raw packets
 

This is the latest recevied telemetry packets stored in our database for station/object CEF4. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>
Time Value1* Value2* Value3* Value4* Value5*
1753646094 129 1 12 15 33
1753643595 129 1 12 15 33
1753641094 129 1 12 15 33
1753638594 128 1 11 14 33
1753636094 130 1 11 15 32
1753633594 130 1 12 15 33
1753631094 130 1 12 15 32
1753628593 130 1 11 15 32
1753626093 130 1 12 15 33
1753618593 130 1 12 15 33
1753616093 130 1 11 15 32
1753613593 130 1 12 15 33
1753611093 130 1 12 15 32
1753608593 130 1 12 15 32
1753606093 130 1 12 15 32
1753603593 130 1 12 15 33
1753601093 130 1 12 15 32
1753598593 130 1 12 15 32
1753596093 130 1 12 15 33
1753591093 130 1 12 15 33
1753588593 130 1 12 15 32
1753586093 130 1 12 15 32
1753583593 129 1 12 15 33
1753581093 130 1 12 15 33
1753578593 130 1 12 15 32
*Used Equation Coefficients:
Value1: 0, 1, 0
Value2: 0, 1, 0
Value3: 0, 1, 0
Value4: 0, 1, 0
Value5: 0, 1, 0

  • The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
  • Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
    The sent equation coefficients is used in the equation: a * value2 + b * value + c.
  • The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
  • The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
  • All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
  • A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)