4K6EH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 4K6EH-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1782178260	642 Count	226 Count	136 Count
1782177356	641 Count	226 Count	136 Count
1782176453	640 Count	226 Count	136 Count
1782175549	639 Count	226 Count	136 Count
1782174646	638 Count	226 Count	136 Count
1782173742	637 Count	226 Count	136 Count
1782172872	636 Count	226 Count	136 Count
1782171935	635 Count	226 Count	136 Count
1782171032	634 Count	226 Count	136 Count
1782170130	633 Count	226 Count	136 Count
1782169309	632 Count	226 Count	136 Count
1782168405	631 Count	226 Count	136 Count
1782167501	630 Count	226 Count	136 Count
1782166648	629 Count	226 Count	136 Count
1782165694	628 Count	226 Count	136 Count
1782164791	627 Count	226 Count	136 Count
1782163888	626 Count	226 Count	136 Count
1782162984	625 Count	226 Count	136 Count
1782162081	624 Count	226 Count	136 Count
1782161177	623 Count	226 Count	136 Count
1782160274	622 Count	226 Count	136 Count
1782159370	621 Count	226 Count	136 Count
1782158467	620 Count	226 Count	136 Count
1782157563	619 Count	226 Count	136 Count
1782156660	618 Count	226 Count	136 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)