EA5DHO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA5DHO-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765522094	8 Count	248 Count	2 Count
1765521922	0 Count	699 Count	0 Count
1765521022	0 Count	660 Count	0 Count
1765520122	0 Count	611 Count	0 Count
1765519222	0 Count	560 Count	0 Count
1765518322	0 Count	526 Count	0 Count
1765517422	0 Count	507 Count	0 Count
1765516522	0 Count	482 Count	0 Count
1765515622	0 Count	459 Count	0 Count
1765483114	0 Count	428 Count	0 Count
1765482214	0 Count	368 Count	0 Count
1765481313	0 Count	305 Count	0 Count
1765480413	0 Count	234 Count	0 Count
1765479513	0 Count	194 Count	0 Count
1765478613	0 Count	161 Count	0 Count
1765477713	0 Count	136 Count	0 Count
1765476813	0 Count	107 Count	0 Count
1765475913	0 Count	82 Count	0 Count
1765475013	0 Count	50 Count	0 Count
1765474113	0 Count	23 Count	0 Count
1765473213	0 Count	1018 Count	0 Count
1765472312	0 Count	975 Count	0 Count
1765471423	0 Count	915 Count	0 Count
1765470992	0 Count	128 Count	0 Count
1765470010	0 Count	128 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)