OK1CDJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1CDJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1788607299	552 Count	531 Count
1788603696	551 Count	531 Count
1788600093	550 Count	531 Count
1788596490	549 Count	531 Count
1788592905	548 Count	531 Count
1788589302	547 Count	531 Count
1788585699	546 Count	531 Count
1788582096	545 Count	531 Count
1788578493	544 Count	531 Count
1788574890	543 Count	531 Count
1788571304	542 Count	531 Count
1788567701	541 Count	531 Count
1788564098	540 Count	531 Count
1788560495	539 Count	531 Count
1788556892	538 Count	531 Count
1788553288	537 Count	531 Count
1788549704	536 Count	531 Count
1788546101	535 Count	531 Count
1788542498	534 Count	531 Count
1788538895	532 Count	519 Count
1788535292	531 Count	518 Count
1788531689	530 Count	518 Count
1788524503	528 Count	516 Count
1788506502	523 Count	515 Count
1788502899	522 Count	515 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)