KF0FFE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KF0FFE-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1785327723	12.53 Volt	100 Pcnt
1785327423	12.53 Volt	100 Pcnt
1785327126	12.53 Volt	100 Pcnt
1785326823	12.53 Volt	100 Pcnt
1785326522	12.53 Volt	100 Pcnt
1785326226	12.53 Volt	100 Pcnt
1785325922	12.53 Volt	100 Pcnt
1785325623	12.53 Volt	100 Pcnt
1785325322	12.53 Volt	100 Pcnt
1785325026	12.53 Volt	100 Pcnt
1785324723	12.53 Volt	100 Pcnt
1785324423	12.53 Volt	100 Pcnt
1785324123	12.53 Volt	100 Pcnt
1785323822	12.53 Volt	100 Pcnt
1785323523	12.53 Volt	100 Pcnt
1785323223	12.53 Volt	100 Pcnt
1785322923	12.53 Volt	100 Pcnt
1785322622	12.53 Volt	0 Pcnt
1785322322	12.53 Volt	0 Pcnt
1785322022	12.53 Volt	0 Pcnt
1785321723	12.53 Volt	0 Pcnt
1785321423	12.53 Volt	0 Pcnt
1785321123	12.53 Volt	0 Pcnt
1785320823	12.53 Volt	0 Pcnt
1785320526	12.53 Volt	0 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)