IZ2WZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ2WZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1776589101	47 Count	499 Count
1776588509	45 Count	485 Count
1776587589	42 Count	461 Count
1776587282	41 Count	448 Count
1776586669	39 Count	427 Count
1776586362	38 Count	413 Count
1776586056	37 Count	405 Count
1776585749	36 Count	396 Count
1776585442	35 Count	385 Count
1776585136	34 Count	377 Count
1776584829	33 Count	369 Count
1776584216	31 Count	351 Count
1776582989	27 Count	317 Count
1776582376	25 Count	301 Count
1776582069	24 Count	290 Count
1776581763	23 Count	279 Count
1776581456	22 Count	269 Count
1776580537	19 Count	243 Count
1776579923	17 Count	223 Count
1776579305	15 Count	202 Count
1776578999	14 Count	192 Count
1776578692	13 Count	181 Count
1776578385	12 Count	174 Count
1776578079	11 Count	162 Count
1776577772	10 Count	148 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)