GM4HYG-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object GM4HYG-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789974858	4 Count	275 Count
1789973958	4 Count	274 Count
1789973058	2 Count	271 Count
1789972158	2 Count	266 Count
1789971258	2 Count	208 Count
1789970358	2 Count	189 Count
1789969458	2 Count	188 Count
1789968558	2 Count	187 Count
1789967658	2 Count	186 Count
1789966758	2 Count	185 Count
1789965858	2 Count	184 Count
1789964958	2 Count	183 Count
1789964060	2 Count	182 Count
1789963160	2 Count	181 Count
1789962260	2 Count	180 Count
1789961360	2 Count	179 Count
1789960459	2 Count	178 Count
1789959559	2 Count	177 Count
1789958659	2 Count	176 Count
1789957759	2 Count	175 Count
1789956859	2 Count	174 Count
1789955959	2 Count	173 Count
1789955059	2 Count	172 Count
1789954159	2 Count	171 Count
1789953259	2 Count	170 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)