SQ8PDY-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8PDY-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1780535680	142 Count	345 Count	54 Count
1780534779	139 Count	334 Count	52 Count
1780533879	135 Count	323 Count	49 Count
1780532978	131 Count	296 Count	46 Count
1780532077	125 Count	277 Count	41 Count
1780531177	122 Count	253 Count	39 Count
1780530276	118 Count	235 Count	36 Count
1780529375	114 Count	214 Count	33 Count
1780528475	110 Count	195 Count	30 Count
1780527574	108 Count	182 Count	29 Count
1780525788	87 Count	138 Count	22 Count
1780523987	58 Count	92 Count	15 Count
1780523086	35 Count	64 Count	6 Count
1780522185	25 Count	46 Count	4 Count
1780516783	179 Count	878 Count	155 Count
1780512279	155 Count	717 Count	136 Count
1780510478	142 Count	615 Count	125 Count
1780508676	106 Count	507 Count	91 Count
1780506875	97 Count	451 Count	84 Count
1780505073	86 Count	338 Count	76 Count
1780501484	53 Count	193 Count	50 Count
1780500585	35 Count	147 Count	33 Count
1780499684	27 Count	103 Count	26 Count
1780494280	118 Count	953 Count	90 Count
1780493380	115 Count	934 Count	88 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)