KC0OOO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KC0OOO-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Sate*	Temp*
1787436230	474	13.6 F
1787436214	472	13.7 F
1787436208	474	13.6 F
1787436158	472	13.5 F
1787436134	479	13.5 F
1787436129	473	13.5 F
1787436117	473	13.5 F
1787436101	469	13.5 F
1787435568	475	13.8 F
1787435549	475	13.8 F
1787435544	472	13.8 F
1787435533	474	13.8 F
1787435512	474	13.7 F
1787435484	472	13.7 F
1787435434	471	13.6 F
1787419827	480	13.8 F
1787419811	479	13.9 F
1787419803	481	13.9 F
1787419763	481	13.8 F
1787419752	479	13.8 F
1787419721	489	13.8 F
1787419715	489	13.8 F
1787419709	490	13.8 F
1787415895	495	11.1 F
1787415890	494	11.1 F

*Used Equation Coefficients:

Sate: 0, 1, 0

Temp: 0, 0.1, -50

Volt: 0, 0.01, 0

Alt: 0, 10, 0

A5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)