SV9KIR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV9KIR-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1765644888	20 Count	50 Count
1765643084	19 Count	48 Count
1765641282	18 Count	46 Count
1765639479	17 Count	43 Count
1765637676	16 Count	41 Count
1765635873	15 Count	39 Count
1765632266	13 Count	35 Count
1765630463	12 Count	34 Count
1765628695	11 Count	26 Count
1765626892	10 Count	23 Count
1765625090	9 Count	21 Count
1765623286	8 Count	19 Count
1765621484	7 Count	17 Count
1765619680	6 Count	15 Count
1765617877	5 Count	13 Count
1765614271	3 Count	9 Count
1765612468	2 Count	7 Count
1765610665	1 Count	5 Count
1765608862	0 Count	3 Count
1765607095	393 Count	1001 Count
1765605292	392 Count	999 Count
1765603489	391 Count	997 Count
1765601686	390 Count	994 Count
1765599883	389 Count	992 Count
1765598080	388 Count	986 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)