SP2PA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2PA-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765562769	346 Count	477 Count	31 Count
1765562729	345 Count	477 Count	31 Count
1765561743	344 Count	477 Count	31 Count
1765559942	343 Count	477 Count	31 Count
1765558141	342 Count	477 Count	31 Count
1765556340	341 Count	477 Count	31 Count
1765554539	340 Count	477 Count	31 Count
1765552758	339 Count	476 Count	31 Count
1765550936	338 Count	475 Count	31 Count
1765549135	337 Count	474 Count	31 Count
1765547344	336 Count	472 Count	31 Count
1765545543	335 Count	472 Count	31 Count
1765543742	334 Count	472 Count	31 Count
1765541941	333 Count	471 Count	31 Count
1765540140	332 Count	470 Count	31 Count
1765538339	331 Count	469 Count	31 Count
1765536538	330 Count	467 Count	31 Count
1765534737	329 Count	466 Count	31 Count
1765532936	328 Count	465 Count	31 Count
1765531136	327 Count	463 Count	31 Count
1765529334	326 Count	456 Count	31 Count
1765527533	325 Count	454 Count	31 Count
1765525743	324 Count	453 Count	31 Count
1765523942	323 Count	451 Count	31 Count
1765522141	322 Count	451 Count	31 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)