SP1GDK-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1GDK-6. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1761506439	628 Count	278 Count
1761505828	627 Count	278 Count
1761505222	626 Count	278 Count
1761504616	625 Count	278 Count
1761504009	624 Count	278 Count
1761502796	622 Count	278 Count
1761502190	621 Count	278 Count
1761501805	620 Count	278 Count
1761501199	619 Count	278 Count
1761500593	618 Count	277 Count
1761499986	617 Count	277 Count
1761499380	616 Count	277 Count
1761498774	615 Count	277 Count
1761497561	613 Count	277 Count
1761496955	612 Count	276 Count
1761496349	611 Count	276 Count
1761495743	610 Count	276 Count
1761495137	609 Count	275 Count
1761493924	607 Count	275 Count
1761493318	606 Count	275 Count
1761492711	605 Count	275 Count
1761491499	603 Count	275 Count
1761490893	602 Count	275 Count
1761490287	601 Count	274 Count
1761489681	600 Count	273 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)