SP2UUU-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2UUU-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1776678308	399 Count	413 Count	399 Count
1776676508	393 Count	407 Count	393 Count
1776674709	391 Count	405 Count	391 Count
1776672909	389 Count	403 Count	389 Count
1776671109	387 Count	401 Count	387 Count
1776669309	385 Count	399 Count	385 Count
1776667509	376 Count	390 Count	376 Count
1776665709	373 Count	387 Count	373 Count
1776663909	371 Count	385 Count	371 Count
1776662109	369 Count	383 Count	369 Count
1776660313	366 Count	380 Count	366 Count
1776658508	361 Count	375 Count	361 Count
1776656708	360 Count	374 Count	360 Count
1776654907	354 Count	368 Count	354 Count
1776653108	352 Count	366 Count	352 Count
1776651308	350 Count	364 Count	350 Count
1776649508	348 Count	362 Count	348 Count
1776647708	346 Count	360 Count	346 Count
1776645908	344 Count	358 Count	344 Count
1776644108	341 Count	355 Count	341 Count
1776642307	338 Count	352 Count	338 Count
1776640507	336 Count	350 Count	336 Count
1776638707	334 Count	348 Count	334 Count
1776636907	333 Count	347 Count	333 Count
1776635107	331 Count	345 Count	331 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)