WCSAR-8 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WCSAR-8. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Temp*
1789955082	12.3 Volt	14.5 C
1789953281	12.6 Volt	15 C
1789949677	12.75 Volt	16 C
1789947875	12.45 Volt	15.5 C
1789946074	12.08 Volt	16 C
1789944272	12.08 Volt	16 C
1789942470	12.08 Volt	16 C
1789940669	12.08 Volt	14 C
1789938868	12.08 Volt	12.5 C
1789937065	12.08 Volt	12 C
1789935265	12.08 Volt	11 C
1789931660	12 Volt	8.5 C
1789929859	12 Volt	8 C
1789928057	11.93 Volt	8 C
1789926255	12 Volt	8.5 C
1789924453	12 Volt	8.5 C
1789922672	11.93 Volt	8 C
1789919050	11.93 Volt	7.5 C
1789917246	11.93 Volt	7 C
1789915446	11.93 Volt	6.5 C
1789913643	11.93 Volt	6 C
1789911841	11.93 Volt	5 C
1789872361	12.08 Volt	12.5 C
1789870560	12.15 Volt	14.5 C
1789868758	12.23 Volt	16 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

U1: 0, 0.1, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

Temp: 0, 0.5, -64

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)