EW1EM-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EW1EM-9. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Temp*
1789981821	12.45 Volt	32 C
1789981521	12.45 Volt	32 C
1789981221	12.45 Volt	32 C
1789980921	12.45 Volt	32 C
1789980621	12.45 Volt	32 C
1789980321	12.45 Volt	32 C
1789980021	12.45 Volt	32 C
1789979721	12.45 Volt	32 C
1789979421	12.45 Volt	32 C
1789979121	12.45 Volt	32 C
1789978821	12.45 Volt	32 C
1789978521	12.45 Volt	32 C
1789978221	12.45 Volt	32 C
1789977921	12.45 Volt	32 C
1789977621	12.45 Volt	32 C
1789977321	12.45 Volt	32 C
1789977021	12.45 Volt	32 C
1789976721	12.45 Volt	32 C
1789976421	12.45 Volt	32.5 C
1789976152	12.45 Volt	32.5 C
1789975821	12.45 Volt	32.5 C
1789975521	12.45 Volt	32.5 C
1789975221	12.45 Volt	32.5 C
1789974921	12.45 Volt	32.5 C
1789974621	12.45 Volt	33 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Temp: 0, 0.5, -64

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)