DG4CB-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG4CB-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789959889	153 Count	20 Count
1789958086	152 Count	20 Count
1789956283	151 Count	20 Count
1789954480	150 Count	20 Count
1789952677	149 Count	20 Count
1789950874	148 Count	20 Count
1789949071	147 Count	20 Count
1789947268	146 Count	20 Count
1789945465	145 Count	20 Count
1789943662	144 Count	20 Count
1789941859	143 Count	20 Count
1789940056	142 Count	20 Count
1789938253	141 Count	20 Count
1789936450	140 Count	20 Count
1789934647	139 Count	20 Count
1789932844	138 Count	20 Count
1789931041	137 Count	20 Count
1789929238	136 Count	20 Count
1789927435	135 Count	20 Count
1789925632	134 Count	20 Count
1789923829	133 Count	20 Count
1789922026	132 Count	20 Count
1789920223	131 Count	20 Count
1789918420	130 Count	20 Count
1789916617	129 Count	20 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)