IU3ISP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU3ISP-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1784683872	14 Count	194 Count	10 Count
1784590257	10 Count	78 Count	4 Count
1784574052	63 Count	747 Count	37 Count
1784563279	41 Count	507 Count	25 Count
1784530854	62 Count	835 Count	35 Count
1784529050	59 Count	802 Count	33 Count
1784520080	41 Count	570 Count	24 Count
1784485837	62 Count	791 Count	36 Count
1784484033	59 Count	748 Count	34 Count
1784482229	57 Count	706 Count	33 Count
1784478622	51 Count	629 Count	29 Count
1784471450	35 Count	459 Count	21 Count
1784453461	2 Count	56 Count	2 Count
1784449853	73 Count	960 Count	43 Count
1784448049	70 Count	912 Count	41 Count
1784446245	67 Count	868 Count	39 Count
1784431856	42 Count	539 Count	26 Count
1784424640	30 Count	360 Count	18 Count
1784421033	24 Count	282 Count	14 Count
1784419229	21 Count	234 Count	12 Count
1784415621	15 Count	149 Count	8 Count
1784413817	12 Count	112 Count	6 Count
1784406641	75 Count	971 Count	45 Count
1784404837	72 Count	944 Count	43 Count
1784392210	51 Count	622 Count	29 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)