2M0JUM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 2M0JUM-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789975070	323 Count	29 Count	29 Count
1789974467	322 Count	29 Count	29 Count
1789973864	321 Count	29 Count	29 Count
1789973261	320 Count	29 Count	29 Count
1789972657	319 Count	29 Count	29 Count
1789972054	318 Count	29 Count	29 Count
1789971451	317 Count	29 Count	29 Count
1789970848	316 Count	29 Count	29 Count
1789970245	315 Count	29 Count	29 Count
1789969642	314 Count	29 Count	29 Count
1789969148	313 Count	29 Count	29 Count
1789968545	312 Count	29 Count	29 Count
1789967941	311 Count	29 Count	29 Count
1789967338	310 Count	29 Count	29 Count
1789966735	309 Count	29 Count	29 Count
1789966132	308 Count	29 Count	29 Count
1789965529	307 Count	29 Count	29 Count
1789964926	306 Count	29 Count	29 Count
1789964323	305 Count	29 Count	29 Count
1789963720	304 Count	29 Count	29 Count
1789963117	303 Count	29 Count	29 Count
1789962514	302 Count	29 Count	29 Count
1789961911	301 Count	29 Count	29 Count
1789961321	300 Count	29 Count	29 Count
1789960705	299 Count	29 Count	29 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)