EB5BZM-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5BZM-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1761502573	256 Count	638 Count
1761502484	255 Count	638 Count
1761502002	254 Count	638 Count
1761501942	253 Count	638 Count
1761501906	252 Count	638 Count
1761501568	251 Count	638 Count
1761501294	250 Count	638 Count
1761501266	249 Count	638 Count
1761501237	248 Count	638 Count
1761501206	247 Count	638 Count
1761500270	246 Count	638 Count
1761496068	244 Count	638 Count
1761493971	243 Count	638 Count
1761491866	241 Count	638 Count
1761489765	240 Count	638 Count
1761487664	239 Count	638 Count
1761483463	236 Count	638 Count
1761479262	234 Count	638 Count
1761476893	232 Count	638 Count
1761474792	231 Count	638 Count
1761472694	230 Count	608 Count
1761470590	229 Count	596 Count
1761468490	228 Count	596 Count
1761466389	227 Count	589 Count
1761464288	226 Count	589 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)